FMCSA opens a public comment period
The Federal Motor Carrier Safety Administration published a notice on November 18 requesting comments on Saia LTL Freight's application for a five-year exemption. Saia wants commercial learner's permit holders enrolled in its driver training program to receive behind-the-wheel training in commercial vehicles configured with double trailers while directly supervised by an experienced CDL holder with a valid doubles/triples endorsement. Comments on docket FMCSA-2026-2642 are due on or before December 18, 2026.
Current doubles and triples rules have not changed
Federal rules prohibit an employer from allowing a driver to operate a commercial motor vehicle without the proper license class and endorsements. A driver must pass the applicable knowledge test to add a doubles/triples, or T, endorsement to a CDL, and State Driver's Licensing Agencies may not add that endorsement to a CLP. The notice is an application for relief from specific requirements in 49 CFR 383.37(a) and 383.93(b)(1), not an FMCSA decision granting the requested exemption.
Saia describes a limited training program
Saia says the requested exemption would cover approximately 300 trainees each year and about 19 training vehicles with gross vehicle weights of 80,000 pounds or less. The company argues that supervised experience with doubles before the final CDL test would streamline its training pipeline and help increase the supply of qualified drivers for its operations. Those figures and expected benefits are the applicant's representations for FMCSA to evaluate, not findings adopted by the agency.
The application proposes four principal safeguards
According to the federal notice, trainees would first pass a company knowledge test designed to mirror the state doubles/triples exam. They would then have to demonstrate proficiency coupling, uncoupling and maneuvering doubles in a closed yard before entering public roads. All on-road training would occur under the direct supervision of a certified trainer or instructor holding a valid Class A CDL with a T endorsement, and trainees would carry proof of their completed internal training and company exam while operating. Training vehicles would remain at or below 80,000 pounds.
FMCSA must apply an equivalent-safety standard
Before granting an exemption, FMCSA must determine that the arrangement would likely achieve a safety level equal to or greater than compliance with the existing rules. The agency will review the application, Saia's safety analysis and public comments, then publish a separate decision granting or denying the request. If granted, that decision would identify the effective period, covered regulatory provisions and binding terms and conditions. Ordinary comments submitted to Regulations.gov are generally posted publicly, including personal information supplied by the commenter.
Driver, school and fleet takeaway
A CLP holder should not operate a double-trailer combination based on this notice. Until FMCSA publishes a final grant, Saia remains subject to the current rules; even a future grant would apply only within its stated scope and conditions, not automatically to another carrier, school or student. Training providers should continue matching every vehicle configuration to the trainee's current permit or CDL authority and the supervising driver's credentials. Fleets or instructors commenting on the proposal should use docket FMCSA-2026-2642, address the requested safeguards and equivalent-safety question with specific operational evidence, and avoid placing unnecessary personal information in the public docket.
Federal Motor Carrier Safety Administration — Saia LTL Freight Exemption Application
This original summary adds CDL-focused context. Visit the named publication for its full reporting and later updates.
Visit source publication →